Transferring Sounds To The TX-200 Transmitter

For FX5, Scorpion, SC5, and OCC Models

Choose the instructions below that match your specific model. Each model requires slightly different transfer procedures.

FX5 Instructions

Critical: The AUX jack plug must be inserted entirely into the jack. If this connection is not secured, the transfer will not work.

  1. 1 Make sure that both your TX-200 transmitter and your FX5 are turned OFF
  2. 2 Plug the supplied stereo patch cable into the AUX (auxiliary) jack on the front of the FX5 and the side jack on the TX-200
  3. 3 Turn on the TX-200 transmitter ONLY. The screen will display "Select Channel Press Send". Verify that you see "B" in the bottom left corner (factory default channel)
  4. 4 Press the send button. Your screen should now say "FX5 Instructions: Hold down arrow Turn on caller". Set your remote down
  5. 5 On the front of the FX5, locate the sound selector buttons (up and down arrows). Press and HOLD the bottom sound selector button (arrow pointing down)
  6. 6 While holding the bottom button, turn on your FX5. When you see numbers scrolling on the FX5 display, release the button
  7. 7 Numbers should now scroll on both the FX5 LCD panel and the TX-200 will display "Transferring Data Please Wait" with a progress bar
  8. 8 When the FX5 numbers reach 199 and the remote says "Transfer Complete", remove the stereo patch cable from both ends and turn off both devices
  9. 9 Turn on your TX-200 transmitter to see your new sounds

Video Tutorial

Scorpion X1A & OCC Instructions

  1. 1 Make sure that both your TX-200 transmitter and your Scorpion or OCC are turned OFF
  2. 2 Plug the supplied stereo patch cable into the AUX (auxiliary) jack on the Scorpion or OCC and the side jack on the TX-200
  3. 3 Turn on the TX-200 transmitter ONLY. The screen will display "Select Channel Press Send". Verify that you see "B" in the bottom left corner (factory default channel). Press the send button
  4. 4 Your screen should now say "Scorpion: Turn on caller". Set your remote down
  5. 5 Inside the Scorpion or OCC, locate the red ON/OFF button. Press it once. Your remote will display "Transferring Data Please Wait". When transfer is complete, remove the cable from both ends and turn off both devices. Turn on your TX-200 transmitter to see your new sounds

Video Tutorial

Snow Crow Pro & SC5 Instructions

  1. 1 Make sure that both your TX-200 transmitter and your SC5 are turned OFF
  2. 2 Plug the supplied stereo patch cable into the AUX (auxiliary) jack inside the SC5 and the side jack on the TX-200
  3. 3 Turn on the TX-200 transmitter ONLY. The screen will display "Select Channel Press Send". Verify that you see "B" in the bottom left corner (factory default channel). Press the send button
  4. 4 Your screen should now say "FX5 Instructions: Hold down arrow Turn on caller". Set down your remote
  5. 5 Inside the SC5, locate the LCD panel and the up/down toggle switch beside it. Pull the toggle switch to the down position and hold it. While holding it down, turn on the SC5. When you see numbers scrolling on the LCD panel, release the toggle switch
  6. 6 Numbers should now scroll on both the SC5 LCD panel and the TX-200 will display "Transferring Data Please Wait" with a progress bar
  7. 7 When the SC5 numbers reach 199 and the remote says "Transfer Complete", remove the stereo patch cable from both ends and turn off both devices. Turn on your TX-200 transmitter to see your new sounds